Week 6 ~ Solder connection board and Jumper
For the week 6 25/11(Friday). Supervisor told me have to solder connection board between controller and the RTC2, After that, also want solder jumper as have bottom pin, because easy to connect between the port controller and port RFID reader. And then, need to solder the pin on controller hardware also.
Then i going to Jalan Pasar, buy the wire and the pin. After that, solder the connection board also use resistor on pin 3 and pin 4. Refer to figure 1 below.
figure 1
For the controller hardware also need to solder the pin as top at beside the hardware. Refer to figure 2 below is doing the soldering, figure 3 is finished solder.
figure 2 : doing soldering
figure 3 : finished solder
Lastly, is construct the pin into the jumper as bottom jumper. Refer the figure 4 below.
figure 4 : doing construction
Thank You for view and read my Blog here.....
Remember to read week 7 blog here again...^.^.....Have a nice day....
No comments:
Post a Comment